The short answer
RoyalFlue sends certified chimney sweeps to Hunters Point homes in 11101 and 11109 from our Greenpoint office about a mile away. We clean soot, creosote and debris from fireplace and boiler flues and inspect the chimney. Plan on a yearly inspection, ideally before heat season starts on October 1.
Hunters Point is about a mile north of our Greenpoint, Brooklyn office, so RoyalFlue crews reach homes in the 11101 and 11109 ZIP codes without a long trip through traffic. The neighborhood mixes older rowhouses and pre-war buildings with newer apartment construction. Chimneys here range from wood-burning fireplaces to masonry flues that vent a boiler or water heater. A chimney sweep removes the soot, creosote and debris that build up inside those flues. It also gives a certified technician a close look at the parts of the system you can't see from the living room.
What a Chimney Sweep Includes
A sweep is more than running a brush up the flue. Our technicians first protect the floor and furniture around the fireplace or appliance. Then they clean the flue from the bottom, the top, or both, depending on how the chimney is built and how safely the roof can be reached. Loose soot and debris are contained with a vacuum so they don't drift into the room.
- Brushing the flue to remove soot and creosote, the tar-like residue from burning wood that can ignite inside the chimney
- Cleaning the smoke chamber, damper and firebox on wood-burning fireplaces
- Clearing nests, leaves and fallen masonry from flues that serve boilers and water heaters
- Checking the damper, chimney cap and visible liner for damage after cleaning
- Photos and a plain written note of anything that needs attention

Chimneys in Hunters Point's Older Rowhouses and Pre-War Buildings
Many older homes in Hunters Point were built with unlined or clay-lined brick chimneys. Over decades, heat, moisture and freeze-thaw cycles loosen mortar and crack flue tiles. Pieces can collect at the base of the chimney or block the flue entirely. A sweep clears that material and shows us whether the flue is still sound.
If your building has switched its boiler from oil to gas, or plans to, the chimney has to be evaluated as part of that work. Gas exhaust produces acidic condensation that can eat into a masonry flue, so a new liner is often needed. We can sweep and inspect the old flue before the conversion so you and your heating contractor know what you're working with.
In newer apartment buildings, gas fireplaces and sealed vent systems still need periodic checks, even though they don't produce creosote.
When to Schedule a Sweep
The NFPA 211 standard calls for chimneys, fireplaces and vents to be inspected once a year. Whether the flue also needs a full cleaning depends on what we find. Most wood-burning fireplaces used regularly through a Queens winter will need one.
New York City's heat season runs from October 1 through May 31, and buildings that rely on a boiler need their venting working the whole time. Booking a sweep in late summer or early fall gets the work done before the system is under constant load. If you're past that point, a mid-season sweep is still worth doing, especially if you notice any of these signs:
- A smoky smell in the room, or smoke that doesn't draw up the flue
- Black, flaky or shiny glazed deposits inside the firebox or on the damper
- Bits of brick, tile or mortar falling into the fireplace
- Animal noises or nesting material near the chimney
Time for your annual chimney check?
Sweeping, Inspection Levels and What Comes Next
Most visits pair a sweep with a Level 1 inspection, which fits when nothing about the chimney or the appliances it serves has changed. A Level 2 inspection, which typically includes a camera run through the flue, is the right step when you install a new appliance, change fuel, or buy or sell a home. A Level 3 inspection is only needed when a hidden hazard has to be reached by opening part of the chimney or the building.
After the sweep, we explain what we saw in plain terms and show you photos. If repairs or a liner make sense, we'll tell you why and let you decide on your own schedule.
Serving Hunters Point and Nearby Neighborhoods
Because our office is close by in Greenpoint, we also sweep chimneys in Long Island City, Sunnyside and Greenpoint itself. We also cross the river to Murray Hill and Kips Bay in Manhattan. The same crews cover all of these areas, so you get the same service in a Queens rowhouse or a Manhattan pre-war building.
More services in Hunters Point
- Chimney Inspection in Hunters PointLocal service & repairs
- Chimney Repair in Hunters PointLocal service & repairs
- Air Duct Cleaning in Hunters PointLocal service & repairs
- Chimney Liner Installation in Hunters PointLocal service & repairs

