Skip to content
Serving Brooklyn and nearby cities Mon–Fri: 8 AM–8 PM · Requests accepted 24/7 · (479) 509-0265

Chimney Repair in Murray Hill, Manhattan

Serving Murray Hill and nearby cities.

Tell us what’s going on

Prefer to talk? (479) 509-0265

The short answer

RoyalFlue repairs chimneys in Murray Hill, Manhattan, including masonry, crowns, caps, flashing, dampers and flue liners on brownstones, rowhouses and pre-war apartment buildings. Every job starts with an inspection to pinpoint the cause, and we explain what needs fixing now and what can wait.

Murray Hill chimneys work hard. Brownstones and rowhouses often still have working fireplaces, and pre-war apartment buildings run boiler flues through most of the heating season. Over time, freeze-thaw cycles, rooftop exposure and acidic exhaust wear down brick, mortar and flue liners. RoyalFlue Chimney Services repairs chimneys for homeowners, co-op boards and building managers in Murray Hill (ZIP codes 10016 and 10168). Our office in Greenpoint, Brooklyn is about 2 miles away. Our certified technicians start by finding out what is actually wrong, then explain the repair in plain terms before any work begins.

Common Chimney Problems in Murray Hill Buildings

Most chimneys in Murray Hill are masonry and many are decades old. A brownstone chimney may have been built for coal or wood and later adapted for gas. A pre-war apartment building may vent a large boiler through a tall brick stack. Each setup wears out in its own way, but the warning signs are similar.

Water is usually the first problem. Rain and melting snow get in through a cracked crown, a missing cap or loose flashing. Once inside, water breaks down mortar, rusts dampers and stains ceilings and walls on the top floor. Damage left alone through a few winters usually leads to a bigger repair.

  • Cracked or crumbling mortar joints and spalling brick
  • Cracked chimney crowns that let water into the flue
  • Missing, rusted or undersized chimney caps
  • Failed flashing where the chimney meets the roof
  • Damaged or deteriorated clay flue tiles
  • Stuck, warped or rusted fireplace dampers
  • White staining (efflorescence) or water marks near the chimney
Chimney Repair at a home

Oil-to-Gas Conversions and Flue Liners

Many Manhattan buildings have switched boilers from oil to gas. When a New York City building converts, the chimney has to be evaluated as part of the work. A new liner is often needed because gas exhaust produces acidic condensate that can corrode a masonry flue that was built for oil.

We inspect the existing flue, check whether it is sized and in good enough condition for the new appliance, and install a liner where one is needed. If your building has already converted but the chimney was never checked, signs like crumbling material at the base of the flue or moisture in the chimney are worth having looked at.

How We Approach a Chimney Repair

We don't quote repairs off a phone description. A technician inspects the chimney, from the roof and from inside where we can reach, and shows you what we found with photos when that helps. The NFPA 211 standard describes three inspection levels. Level 1 covers a chimney when nothing has changed. Level 2 applies when the system changes, such as a new appliance or a fuel switch, or when the home is sold. Level 3 is for hidden hazards that can only be reached by opening part of the chimney or building.

After the inspection, we separate urgent safety and water problems from items that can be planned for later. In a co-op or condo building, we can share findings with the board or managing agent so roof access and scheduling go smoothly.

Time for your annual chimney check?

Timing Repairs Around Heat Season

New York City's heat season runs from October 1 through May 31. During that time, building owners must keep apartments heated to the city's minimum temperatures. A boiler flue problem found in January is harder to deal with because the heat can't simply be turned off for days.

For that reason, late spring and summer are usually the easiest times for liner work and larger masonry repairs on boiler chimneys. Fireplace owners in brownstones also benefit from fixing crowns, caps and dampers before the first fires of the fall. If something urgent turns up in the middle of winter, we work out a plan that keeps the building safe and heated.

Nearby Neighborhoods We Serve

Along with Murray Hill, we handle chimney repair in Kips Bay, Gramercy, Stuyvesant Town, Peter Cooper Village and the East Village. The housing in these neighborhoods ranges from rowhouses to large pre-war and postwar apartment buildings, and our technicians are used to working on both.

More services in Murray Hill

Related

Chimney sweep cleaning a brick chimney on a rowhouse roof

Book Chimney Repair in Murray Hill

Serving Murray Hill and nearby cities.

  • Diagnosis before any repair
  • Written price up front
  • Written price before we start

What to expect

How a visit goes

  1. We explain the problem first

    Before we suggest any repair, we show you where the problem is and why it matters, using photos from inside your chimney or vent.

  2. We protect your home while we work

    We cover floors and furniture near the work area and seal the fireplace opening so soot stays in the chimney and out of the room.

  3. We recommend only what the system needs

    A dirty flue gets swept. A sound chimney does not get a liner just because it is old. We match the work to what we actually find.

FAQ

Common questions

Don’t see your question? Call (479) 509-0265 and we’ll talk it through.

How do I know if my chimney needs repair?

Common signs include water stains near the chimney, crumbling mortar, loose bricks, flakes of tile in the fireplace, a damper that sticks, or a smoky smell. An inspection is the surest way to find the cause.

Does my building need a new liner after switching from oil to gas?

Not always, but often. In New York City the chimney has to be evaluated during an oil-to-gas conversion. Gas exhaust creates acidic condensate that can corrode an unlined or worn masonry flue, so a new liner is frequently required.

Can you repair a brownstone fireplace chimney?

Yes. We repair crowns, caps, flashing, mortar, dampers and flue liners on brownstone and rowhouse chimneys, whether the fireplace burns wood or has been converted to gas.

How often should a chimney be inspected?

The NFPA 211 standard calls for chimneys, fireplaces and vents to be inspected once a year. Yearly checks catch small problems before they turn into major repairs.

When is the best time to schedule chimney repairs in Manhattan?

Outside heat season, which runs from October 1 through May 31, is usually easiest for boiler chimney work. For fireplaces, late summer gives you time to finish repairs before fall.

Are your technicians certified?

Yes, our technicians are certified, and they explain what they find and what each repair involves before any work starts.

Schedule a Chimney or Vent Inspection

Tell us what you are noticing and what kind of building you live in. We will set up a visit, inspect the system, and give you a written price before any work begins.

Call (479) 509-0265 Request Service